Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 1

12.2.2 Setting up JP1/AJS3 - Agent

This subsection describes how to set up JP1/AJS3 - Agent. Before you set up JP1/AJS3 - Agent, make sure that you have superuser permissions.

After you have set up JP1/Base, make sure that JP1/AJS3 - Manager to which you want to connect JP1/AJS3 - Agent is operating normally before attempting to set up JP1/AJS3 - Agent.

Make sure that the umask for the user who starts JP1/AJS3 permits viewing and updating by any user who executes JP1/AJS3 commands.

Note that this subsection describes the basic setup of JP1/AJS3. If you need to change the settings to match specific operating requirements, see the appropriate section listed in the following table.

Topic Reference

Procedure for setting environment setting parameters 13.2

Settings for defining the work path to be used during job execution as a variable 14.2.1

Changing the timeout value for pipe communication of the agent 14.2.15

Setting the timeout value for receiving notification from the job process that execution is ready 14.2.16

Changing the settings related to the size of the log for event jobs to match operational requirements 14.3.1

Setting the status passing option for the file monitoring job 14.3.3

Settings for monitoring a large file (file whose size is 2 GB or larger) 14.3.12

Settings for automatic startup and termination of the JP1/AJS3 service 14.7.1

Settings for the JP1/AJS3 definition pre-check function 14.5.1

Settings for logging 15

Setting up for a cluster system 16

Organization of this subsection

(1) Setup procedure

Topic	Reference
Procedure for setting environment setting parameters	13.2
Settings for defining the work path to be used during job execution as a variable	14.2.1
Changing the timeout value for pipe communication of the agent	14.2.15
Setting the timeout value for receiving notification from the job process that execution is ready	14.2.16
Changing the settings related to the size of the log for event jobs to match operational requirements	14.3.1
Setting the status passing option for the file monitoring job	14.3.3
Settings for monitoring a large file (file whose size is 2 GB or larger)	14.3.12
Settings for automatic startup and termination of the JP1/AJS3 service	14.7.1
Settings for the JP1/AJS3 definition pre-check function	14.5.1
Settings for logging	15
Setting up for a cluster system	16

(1) Setup procedure

To set up JP1/AJS3 - Agent:

If necessary, change the environment setting parameters.
Skip this step if you accept the environment setting parameter values proposed by JP1/AJS3. To change environment setting parameter values, use the jajs_config command, or the jbssetcnf command provided by JP1/Base.
For details about the jajs_config command, see jajs_config in 2. Commands Used during Setup in the manual Job Management Partner 1/Automatic Job Management System 3 Command Reference 2. For details on the jbssetcnf command, see the Job Management Partner 1/Base User's Guide.

Set up the system and user environments.
For details about setting up the system and user environments, see 12.4 Setting up the system and user environments.

If necessary, set the method for automatic startup and termination of the JP1/AJS3 service.
For details about setting the method for automatic startup and termination of the JP1/AJS3 service, see 14.7.1 Setting automatic startup and termination of the JP1/AJS3 service.

JP1/AJS3 - Agent setup is complete.

[Contents][Back][Next]

[Trademarks]