Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 1

14.3.12 Enabling monitoring of a large file

This subsection describes how to enable large file (2 GB or larger) monitoring that uses a file monitoring job, and large-file evaluation that uses a judgment job.

Organization of this subsection

(1) Definition procedure

(2) Environment setting parameter

(1) Definition procedure

(a) For a standard configuration

1. Stop the JP1/AJS3 service.
   Execute the following commands to confirm that all processes have stopped:
   

    
   # /etc/opt/jp1ajs2/jajs_stop#1
   # /opt/jp1ajs2/bin/jajs_spmd_status
    

   #1:

   Confirm that automatic termination has been set.

2. Execute the following command to set the environment setting parameter described in (2) below:
   

    
   jajs_config -k definition-key "parameter-name"=value
    

3. Restart JP1/AJS3.
   The new settings are applied.
   

(b) For a compatible ISAM configuration

1. Stop the JP1/AJS3 service.
   Execute the following commands to confirm that all processes have stopped:
   

    
   # /etc/opt/jp1ajs2/jajs_stop#1
   # /opt/jp1ajs2/bin/jajs_spmd_status
    

   #1:

   Confirm that automatic termination has been set.

2. In an editor such as vi, create a configuration file that defines the environment setting parameter described in (2) below.
3. Save the file and then execute the following command:
   

    
   jbssetcnf configuration-file-name
    

   The path of the jbssetcnf command is /opt/jp1base/bin/jbssetcnf. For details on this command, see the Job Management Partner 1/Base User's Guide.
   
4. Restart JP1/AJS3.
   The contents of the configuration file are applied to the system.
   

(2) Environment setting parameter

Table 14-39 Environment setting parameter used for large-file monitoring and evaluation

Definition key	Environment setting parameter	Explanation
[{JP1_DEFAULT|logical-host}\JP1AJS2COMMON]#	"LARGEFILEUSE"=	Specifies whether to support large files.

#:

The specification of the {JP1_DEFAULT|logical-host} part depends on whether the host is a physical host or a logical host. For a physical host, specify JP1_DEFAULT. For a logical host, specify the logical host name.

For details about the definition of this environment setting parameter, see 2.9(1) LARGEFILEUSE in the Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 2.

[Contents][Back][Next]

Copyright (C) 2009, 2010, Hitachi, Ltd.
Copyright (C) 2009, 2010, Hitachi Solutions, Ltd.