Job Management Partner 1/Base User's Guide

6.2.1 Specifying the directory server to be linked

If you want to perform login authentication linking with the directory server, you must set up the common definition information from the authentication server. The directory server linkage function is disabled by default, so you must change the setting. If you use a secondary authentication server, set up the function on both the primary authentication server and secondary authentication server.

To change the directory server settings:

Edit the directory server linkage definition file (jp1bs_ds_setup.conf).
For details on the directory server linkage definition file, see Directory server linkage definition file (Windows only) in 14. Definition Files.

Execute the jbssetcnf command.
The settings are reflected in the common definition information.

Execute the jbschkds command.
You can check the settings of directory server linkage. You can check the following by executing the jbschkds command:

Whether the directory server linkage function is enabled

Directory server name to be linked

Destination port number of the directory server to be connected

Whether SSL is to be used

ID

Whether the connection to the directory server was successful

Whether the user authentication was successful

For details on the jbschkds command, see jbschkds (Windows only) in 13. Commands.

[Contents][Back][Next]

[Trademarks]