Job Management Partner 1/Integrated Management - Manager Quick Reference

4.3.2 Verifying that the corrective action is registered

After you have finished using the event guide function to set the event guide information, check whether the corrective action you set for the event is registered.

To check whether the corrective action is registered:

1. Using the procedure given in 1.2.2 Verifying that you can execute a command, enter the following settings in the Execute Command window.
   

   Item	Setting to enter
   Target host	hostA
   Command	jevsend -e SEVERITY=Error

   On host A, an error-level event is issued.
   
2. Select the issued event in the events list and, in the Event Console window, choose View, and then Event Details.
   Event guide information for the selected event is displayed in the Event Details window.
   

For this example, verify that the following is displayed:

Keywords:

corrective action, event, event guide, error, event guide information

Tip:

To start an application that is linked to the event:

Select an event, and then, in a separate window, start the application that has been linked to the displayed event. For details about how to set up this link, see 4.12 Setting monitor startup for linked products in the Configuration Guide.

[Contents][Back][Next]

All Rights Reserved. Copyright (C) 2009, Hitachi, Ltd.