Job Management Partner 1/Integrated Management - Manager Quick Reference

2.3.2 Verifying that events from unmonitored hosts are not displayed

After you have specified the common exclusion conditions for the filter, make sure that events from the unmonitored hosts are not being displayed in the events list.

To verify that events from the unmonitored hosts are not being displayed:

1. Click the OK button in the Common Exclusion-Condition Settings window.
   The Event Acquisition Conditions List window is displayed.
   
2. Click the OK button in the Event Acquisition Conditions List window.
   The System Environment Settings window appears.
   
3. Click Apply in the System Environment Settings window.
   The specified conditions are defined.
   
4. Using the procedure given in 1.2.2 Verifying that you can execute a command, enter the following settings in the Execute Command window.
   

   Item	Setting to enter
   Target host	hostA
   Command	jevsend -e SEVERITY=Warning -m Command executed from host A.

   On host A, an event of severity level Warning is issued.
   
5. Repeat step 4. Enter the following settings in the Execute Command window.
   

   Item	Setting to enter
   Target host	hostB
   Command	jevsend -e SEVERITY=Warning -m Command executed from host B.

   On host B, an event of severity level Warning is issued.
   
6. Repeat step 4. Enter the following settings in the Execute Command window.
   

   Item	Setting to enter
   Target host	hostC
   Command	jevsend -e SEVERITY=Warning -m Command executed from host C.

   On host C, an event of severity level Warning is issued.
   

For this example, verify that only events of severity level Warning that are issued by host C are displayed in the events list, and that events of severity level Warning that are issued by hosts A and B are not displayed in the events list.

Keywords:

item, filter, common exclusion condition, specific, host

[Contents][Back][Next]

All Rights Reserved. Copyright (C) 2009, Hitachi, Ltd.