9. Commands

This chapter explains the commands used in HA Monitor.

Organization of this chapter

• 9.1 List of commands

• 9.2 Headings used in the explanations of commands

• 9.3 Syntax symbols

• 9.4 monact (starts a server in the wait state as the active server)

• 9.5 monbegin (starts a server in the monitor mode)

• 9.6 monchange (changes settings and operations while HA Monitor and servers are running)

• 9.7 moncheck (checks definitions)

• 9.8 mondeact (terminates a server in the wait state)

• 9.9 mondevice (changes shared resources while the active server is running)

• 9.10 monend (terminates servers in the monitor mode)

• 9.11 moninfo (specifies server information in the active system that is to be inherited, or references and displays inherited server information in the standby system)

• 9.12 monlink (connects HA Monitors manually)

• 9.13 monlistip (detects IP addresses)

• 9.14 monodrshw (displays the server order control status)

• 9.15 monpath (displays the status of monitoring paths)

• 9.16 monresbgn (starts a resource server)

• 9.17 monresend (terminates an active resource server)

• 9.18 monressbystp (terminates a standby resource server)

• 9.19 monrp (displays the status of the reset path)

• 9.20 monsbystp (terminates a standby server)

• 9.21 monscsiclr (releases reservations for shared disks)

• 9.22 monsetup (specifies HA Monitor environment settings)

• 9.23 monshow (displays the status of servers and hosts)

• 9.24 monstart (starts HA Monitor)

• 9.25 monstop (terminates HA Monitor)

• 9.26 monswap (performs server hot-standby switchover)

• 9.27 monts (collects HA Monitor troubleshooting information)

To Page Top