6.7 Configuring the reset path (BladeSymphony)

If the system being used is BladeSymphony, you must configure a reset path so that in the event of a host failure HA Monitor can reset the host.

Important

When a reset path is configured, HA Monitor checks whether it is possible to communicate with a failure management processor and VMware ESXi. Therefore, before you configure a reset path, make sure that the settings for a failure management processor and VMware ESXi have been specified completely.

You use an HA Monitor environment setup command (monsetup command) to configure the reset path. For details about the HA Monitor environment setup command (monsetup command), see 9.22 monsetup (specifies HA Monitor environment settings) in 9. Commands.

Organization of this section

• 6.7.1 Information required for configuration (BladeSymphony)

• 6.7.2 Examples of settings (BladeSymphony)

To Page Top