16.19.1 Terminating the HADB server normally
Before migrating to a system that uses the multi-node function, terminate the HADB server normally.
If the HADB server has already terminated, check the following two points to make sure that it terminated normally:
-
Whether STOP is displayed under the output item STATUS of the adbls -d srv command
-
Whether the termination mode in message KFAA91154-I, output in the message log file or syslog, is normally (normal termination)
If the HADB server did not terminate normally, start it by executing the adbstart command, and then terminate it normally by executing the adbstop command.