16.17.3 Deleting nodes

The following procedure shows how to delete nodes that are no longer necessary:

Procedure:

1. Normally terminate the multi-node configuration HADB server

   For details about the procedure for terminating the HADB server normally in a multi-node configuration, see (a) Normally terminating HADB servers in the multi-node configuration in (1) Termination procedures for HADB servers in a multi-node configuration under 16.4.2 Terminating HADB servers in the multi-node configuration.

2. Correct the server definition

   Delete the information for the node you are deleting from the adb_sys_multi_node_info operands in the server definitions of the HADB servers on all nodes.

3. Start the multi-node configuration HADB server

   For details about the procedure for starting the HADB server in a multi-node configuration, see 16.4.1 Starting the HADB servers in the multi-node configuration.

To Page Top