11.18.5 Action to be taken when an error related to the updated-row columnizing facility occurs
If an error related to the updated-row columnizing facility occurs, either of the following messages is output. How to take action if these messages are output is explained later.
-
KFAA51280-W
This message is output if an error occurs during the maintenance processing.
-
KFAA41220-W
This message is output if an error occurs in the processing that starts I/O control of files used by the updated-row columnizing facility.
- Organization of this subsection
(1) If an error occurs during the maintenance processing (KFAA51280-W)
If an error occurs during the maintenance processing, the KFAA51280-W message is output to a message log file. In this case, handle the error by referring to the action indicated in the KFAA51280-W message.
If you leave the updated-row columnizing facility enabled without handling the error, the maintenance processing is re-executed every six hours, and therefore the same error occurs again (the KFAA51280-W message is output again).
(2) If an error occurs in the processing that starts I/O control of files used by the updated-row columnizing facility (KFAA41220-W)
When the HADB server starts, the system performs the processing that starts I/O control of files used by the updated-row columnizing facility. If an error occurs while the system is performing the processing that starts I/O control of files used by the updated-row columnizing facility, the KFAA41220-W message is output to a message log file. In this case, handle the error by referring to the action indicated in the KFAA41220-W message. If you leave the updated-row columnizing facility enabled without handling the error, the maintenance processing is re-executed every six hours. At this time, the system again attempts to perform the processing that starts I/O control of files used by the updated-row columnizing facility. Therefore, the same error occurs again (the KFAA41220-W message is output again).