3.12.3 The KFAA91104-Q message is output during startup of the HADB server
This subsection explains the action to take if the KFAA91104-Q message is output when the HADB server startup command (adbstart command) is executed.
The KFAA91104-Q message (asking whether you want to delete the troubleshooting information) is output if the adbstart command is executed after the OS was shut down without the HADB server termination command (adbstop command) being executed while the HADB server was running.
- ■ KFAA91104-Q message output example
-
KFAA90000-I adbstart processing started. KFAA91104-Q Are you sure you want to discard trouble shoot information? (y/N)
The HADB server terminated abnormally because it was not terminated according to the correct procedure, and as a result, troubleshooting information has been output.
Because the troubleshooting information that was output is not necessary in the hands-on environment built in this chapter, delete it.
- Important
-
If the KFAA91104-Q message is output during execution of the adbstart command in an environment used in actual operations instead of in a hands-on environment, check the appropriate location to collect troubleshooting information. For details, see the notes under adbstart (Start the HADB Server) in the manual HADB Command Reference.
Click Y in response to the KFAA91104-Q message. Clicking Y deletes the troubleshooting information, and then the HADB server starts.
- ■ Example of a message output after Y is clicked
-
KFAA91105-I The HADB system was started normally. (HADB server operation mode = "NORMAL") KFAA90001-I adbstart processing ended. (return code = 0)
If the return code is 0, the HADB server has started.