stsrm -f physical-file-name

The stsrm command deletes a status file.

This command cannot delete a status file being used (on current or standby status) by the status service in the online mode.

-f physical-file-name~<path name>

Specifies the name of a physical file to be deleted.

Message ID	Description	Output destination
KFCA01040-E	Error occurred in physical file.	Standard error output
KFCA01070-E	Error occurred during stsrm command processing.	Standard error output
KFCA01082-I	Help message	Standard output, standard error output
KFCA01091-E	Memory is inadequate.	Standard error output
KFCA01099-E	Error occurred during OpenTP1 function call.	Standard error output

Because a current status file is managed only while the status service is active, the following must be noted about executing the stsrm command:

• A current status file being used in the online mode must not be deleted.
• Only a status file placed on shutdown status due to an error should be deleted.