mcftstart -s MCF-communication-process-identifier

The mcftstart command starts part of an MCF communication service.

When you replace some files of an MCF communication service, replace the files and execute this command to start part of the target MCF communication service.

-s MCF-communication-process-identifier~<numerals (0-9), a-f> ((01-ef))

Specify the MCF communication process identifier of the MCF communication service that you want to start partially. You cannot specify multiple MCF communication process identifiers.

Message ID	Description	Output destination
KFCA10350-I	The mcftstart command has been entered.	Standard output
KFCA10351-E	The MCF is being started.	Standard error output
KFCA10352-E	The MCF is being ended.	Standard error output
KFCA10353-W	The input format is incorrect.	Standard error output
KFCA10354-E	Memory is insufficient.	Standard error output
KFCA10355-W	The specified argument is incorrect.	Standard error output
KFCA10356-E	A timeout error occurred.	Standard error output
KFCA10358-E	An error occurred in an internal function.	Standard error output
KFCA10359-W	A response to the source of the mcftstart command failed.	Message log file
KFCA10370-I	The mcftstart command has been accepted successfully.	Standard output
KFCA10372-E	The mcftstart command ended abnormally.	Standard error output
KFCA10380-E	A search for the target process failed.	Standard error output
KFCA10391-E	The mcftstart command is not supported.	Standard error output
KFCA16523-I	Partial start of the MCF communication service is being prepared.	Message log file
KFCA16524-I	The MCF communication service is now partially started.	Message log file
KFCA16525-E	An OpenTP1 end command was executed during the partial start of the MCF communication service.	Message log file
KFCA16527-E	The MCF communication service is not inactive.	Standard error output
KFCA16529-E	A feature that cannot be used together with this feature is being used.	Standard error output

• This command ends without waiting for the completion of the partial start of the MCF communication service.
• Partial start is only available for the MCF communication services (including the application startup service) that use the following protocol products. If you execute partial start of the MCF communication services that use other protocol products, the KFCA10391-E message appears.
  
  • TP1/NET/TCP/IP
  • TP1/NET/Secondary Logical Unit - TypeP2
  • TP1/NET/OSAS-NIF
• MCF communication services cannot be partially started in a system that uses independent rerun of MCF services or a system that provides remote MCF services. If you execute partial start in such systems, the KFCA16529-E message appears.
• User timer monitoring requests before partial stop of an MCF communication service are valid even if the target MCF communication service becomes partially stopped. User timer monitoring requests that are issued to the MCF communication service in partial stop status are also registered. Timer monitoring is not performed while the target MCF communication service is partially stopped. However, the partial stop is included in the elapsed time. Therefore, when timer monitoring begins when the target MCF communication service partially starts after a partial stop, the system may detect a timeout error and UAPs may be started.