OpenTP1 Version 7 Operation
The next time OpenTP1 was started after a successful shutdown, the following message appears and the start mode is set to restart.
KFCA01803-I OpenTP1 start mode is determined. start mode: R |
The most likely cause is that the status file was manipulated in some way (a definition was changed or the file was restored) while OpenTP1 was stopped.
Investigate the cause of the error using the flow chart below.
Figure 11-9 Troubleshooting procedure when message KFCA01803-I is output
All Rights Reserved. Copyright (C) 2006, 2010, Hitachi, Ltd.