Map file

OpenTP1 Version 7 Operation

5.7.3 Map file

The mapping service facility is available under the TP1/NET/XMAP3 protocol or TP1/NET/HNA-560/20 protocol.

The dcmapchg command and dcmapls command can only be used under the TP1/NET/XMAP3 or TP1/NET/HNA-560/20 protocol.

For details about the mapping service facility, see the manual OpenTP1 Protocol TP1/NET/XMAP3 or OpenTP1 Protocol TP1/NET/HNA-560/20.

Organization of this subsection: (1) Change of path name; (2) Display of resources

(1) Change of path name

Use the dcmapchg command to change the current map under the mapping service facility. The dcmapchg command can change the path name of the following map files.

Standard physical map input path
Alternate physical map input path
Standard PAGEC module input path
Alternate PAGEC module input path

(2) Display of resources

Loaded physical maps or PAGEC modules can be displayed by using the dcmapls command with the -s option.

The dcmapls command with the -p option displays the path name of the map file.