H.4 Adding data to post-change management relay server

Add ID groups that were being managed by a pre-change management relay server to a post-change management relay server.

• Create ID groups that were being managed by a pre-change management relay server.

  1. For an ID group created with a higher system, register the post-change management relay server from the higher system to the ID group management relay.

  2. For an ID group created with a pre-change management relay server, create an ID group on the post-change management relay server.

     If a lower relay system has been registered as a management relay with a pre-change management relay server, register to the management relay.

     Figure H‒5: ID group registration

• When using Remote Install Manager, select Use File for ID Registration from the File menu in the Remote Install Manager's Destination window, and register the ID hosts.

For details, see 5.3.2 Creating ID groups and 5.3.3 Registering managed computers in ID groups.

To Page Top