H.3 Changing connection destination of host managed on pre-change management relay server to post-change management relay server

Change the connection destination of a host under the pre-change management relay server to the post-change management relay server.

When the function for automatic registration into the system configuration is being used and the connection destination of a host under the pre-change management relay server has been changed to the post-change management relay server, it will be reflected in the system configuration.

Changing the relay system connection destination

If a relay system exists under the pre-change management relay server, change the lower relay system's connection destination to the relay system on the post-change management relay server side.

For a Windows relay system, change the connection destination via setup.

For a UNIX relay system, change the connection destination of the configuration file.

Figure H‒3: Changing connection destination of management relay server and relay system under management relay server

Figure H‒4: Changing connection destination of relay system under relay system

If you wish to immediately reflect system configuration information as a batch from Remote Install Manager, create from a file.

Organization of this subsection

(1) Acquiring system configuration information with pre-change management relay server
(2) Adding system configuration information with post-change management relay server

(1) Acquiring system configuration information with pre-change management relay server

For management relay server: With the pre-change management relay server, save the system configuration information to a file by selecting Save to File from the File menu in the Remote Install Manager's System Configuration window.
For relay system: Select Save to File from the File menu in the Remote Install Manager's Destination window, and save to a file.

To Page Top

(2) Adding system configuration information with post-change management relay server

Take system configuration information that was being managed by the pre-change management relay server and add it to the post-change management relay server.

For management relay server

Select Save to File from the File menu in the Remote Install Manager's System Configuration window, and acquire system configuration information to a file.
Merge with the system configuration information acquired from the pre-change management relay server.
After merging, select Create from File from the File menu in the Remote Install Manager's System Configuration window, and create system configuration information.

For relay system

Select Save to File from the File menu in the Remote Install Manager's Destination window, and acquire destination information to a file.
Merge with the destination information acquired from the pre-change management relay server.
After merging, select Create from File from the File menu in the Remote Install Manager's Destination window, and create destination information.

For details, see the following:

Changing connection destination using remote installation

3.4.3 Automatically changing the agent connection destination

System configuration information acquisition job

5.1.6 Collecting system configuration information of the systems under management relay servers

System configuration information

To Page Top