7.2.3 Notes on Define Details window
This section describes notes on the use of the Define Details window.
- About restrictions on entered values
-
If you enter characters including multibyte characters, the multibyte characters are counted after UTF-8 byte calculation is performed.
If multibyte characters are included, take into consideration the number of UTF-8 bytes before you enter the characters.
In addition, the value entered or selected in the Define Details window will be saved in the subsequent unit definition parameter of JP1/AJS.
-
For service linkage jobs: env
-
For service linkage monitoring jobs: cprm
For the above-mentioned definition parameters, the maximum total entry size is defined. For this reason, if the value entered in the detailed definition window is within the stipulated range, the KNBB4009-E message might be issued and the definition might fail. In addition, there are values that will automatically be output by the detailed definition window. Therefore, take into consideration the values that will be output by the detailed definition window and make sure that the maximum size will not be exceeded.
For details, see 4.5 Unit definition parameters of service linkage jobs and 4.6 Unit definition parameters of service linkage monitoring jobs.
-