15.2.10 Execution Generation dialog box
The Execution Generation dialog box displays a list of execution generations of a root jobnet. The items to be displayed in
this dialog box can be set by using the Setting dialog box.
The following figure shows the Execution Generation dialog box.
The following explains operations that can be performed from the Change Plan drop-down list:
-
If you select Execution Prohibited, you can cancel the scheduled execution of the selected execution generation.
-
If you select Prohibit Execution of Retention Generations, you can perform batch cancellation of all execution generations in Wait for start cond. status in the list. Execution of each target generation is canceled at three-second intervals.
You can manipulate a unit by selecting it in the list and clicking the buttons above the list. The following table describes
the operations that can be performed by using these buttons.
Table 15‒8: Operations that can be performed by clicking the buttons in the Execution Generation dialog box
No.
|
Button
|
Operation
|
1
|
Hold-On#
|
Holds the selected unit.
|
2
|
Hold-Off#
|
Releases the selected unit from the hold.
|
3
|
Interrupt#
|
Interrupts execution of a jobnet.
|
4
|
Kill#
|
Forcibly terminates a unit that is running.
|
5
|
Rerun#
|
Displays the Rerun dialog box, allowing you to rerun a unit.
|
6
|
Change Plan#
|
Displays the following menu commands, which allow you to perform operations such as temporarily changing the selected execution
schedule and releasing the execution schedule from the temporary changes:
-
Change Time
Displays the Change Time dialog box, in which you can change the scheduled start date and time of the execution schedule of
the selected unit.
-
Execute Immediately
Displays the Execute Immediately dialog box, in which you can immediately execute the execution schedule of a selected unit.
-
Execution Prohibited
Cancels the scheduled execution of the selected execution generation.
-
Prohibit Execution of Retention Generations
Performs batch cancellation of all execution generations in Wait for start cond. status in the list.
-
Release Change
Releases the execution schedule of the selected unit from temporary changes.
|
- #
-
If the operation restriction function of the job portal is enabled, these buttons appear only if the logged-in user is a user
who is permitted to perform the corresponding operations.
To Page Top