15.2.8 Monitor dialog box
In the Monitor dialog box, you can view lines showing the relations between units under the unit selected in the Dashboard screen or List screen. You can also perform operations such as Change Hold Attribute, Interrupt, and Rerun.
The following figure shows the Monitor dialog box.
The Monitor dialog box consists of two main areas:
- Tree area
-
Defined jobnets are displayed in a tree. If you select a jobnet in the tree area, the map area displays the units under the selected jobnet.
- Map area
-
Units under the jobnet selected in the tree area are displayed. In the tool tip of the icon for a unit, you can check the unit name and the comment defined for the unit.
If automatic refresh is enabled, the Monitor dialog box is refreshed every 5 minutes, starting from the time that automatic refresh is enabled. The automatic refresh interval can be changed in the Setting dialog box.
You can manipulate a unit by selecting it and clicking the buttons at the top of the dialog box. The following table describes the operations that can be performed by using these buttons.
No. |
Button |
Operation |
---|---|---|
1 |
Hold-On# |
Holds the selected unit. |
2 |
Hold-Off# |
Releases the selected unit from the hold. |
3 |
Interrupt# |
Interrupts execution of a jobnet. |
4 |
Kill# |
Forcibly terminates a unit that is running. |
5 |
Rerun# |
Displays the Rerun dialog box, allowing you to rerun a unit. |
6 |
Change Status# |
Displays the Change Job Status dialog box, allowing you to change the status of a job. |
7 |
Change Plan# |
Displays the following menu commands, which allow you to perform operations such as temporarily changing the selected execution schedule and releasing the execution schedule from the temporary changes:
|
8 |
Detail |
Displays the Detailed Information dialog box, allowing you to check the detailed information about a unit. |
9 |
Result |
Displays the Execution Result Details dialog box, allowing you to check the execution result of a unit. |
10 |
Inheritance |
Displays the Inherit Result dialog box, allowing you to check the inheritance result of a unit. |
11 |
Waiting |
Displays the Wait Conditions Statuses dialog box, allowing you to check the wait status of a unit. |
You can switch the information shown under the icon for each unit displayed in the map area between the unit name and the comments defined for the unit. Clicking the Unit name button at the top of the map area displays unit names. Clicking the Comment button at the top of the map area displays the comments defined for the units. If no comment is defined for a unit, nothing is displayed under the icon for the unit.
You can copy the URL of the Monitor screen for a specific unit. To do this, select the unit in the Monitor dialog box, and then click the URL Copy button at the bottom of the dialog box. For details about the Monitor screen, see 15.2.9 Monitor screen. Note that to use the obtained URL to open the Monitor screen, you must perform authentication by using the JP1/AJS3 - Web Console login screen.
The function that copies the URL of the Monitor screen is useful when you want to inform other users by email of the URL of the Monitor screen for a monitored unit.
- List of screens that can be displayed from the Monitor dialog box:
-
No.
Screen
Relevant section
1
Rerun dialog box
2
Change Job Status dialog box
3
Detail Information dialog box
4
Define Details dialog box
5
Execution Result Details dialog box
6
Inherit Result dialog box
7
Change Time dialog box
8
Execute Immediately dialog box
9
Wait Conditions Statuses dialog box