9.13 Changing the lower-level definition of a jobnet registered for execution
This subsection shows how to change the lower-level definition of a jobnet registered for execution.
You can also change the lower-level definition of a jobnet registered for execution by executing the ajssuspend command and then executing one of the following commands. For details on how to use the following commands, see the description of ajssuspend in 3. Commands Used for Normal Operations in the manual JP1/Automatic Job Management System 3 Command Reference.
-
ajsdefine command
For details of the command, see the description of ajsdefine in 3. Commands Used for Normal Operations in the manual JP1/Automatic Job Management System 3 Command Reference.
-
ajsdelete command
For details of the command, see the description of ajsdelete in 3. Commands Used for Normal Operations in the manual JP1/Automatic Job Management System 3 Command Reference.
-
ajscopy command
For details of the command, see the description of ajscopy in 3. Commands Used for Normal Operations in the manual JP1/Automatic Job Management System 3 Command Reference.
-
ajschgnet command
For details of the command, see the description of ajschgnet in 3. Commands Used for Normal Operations in the manual JP1/Automatic Job Management System 3 Command Reference.
-
ajsrestore command
For details of the command, see the description of ajsrestore in 3. Commands Used for Normal Operations in the manual JP1/Automatic Job Management System 3 Command Reference.
-
ajsimport command
For details of the command, see the description of ajsimport in 3. Commands Used for Normal Operations in the manual JP1/Automatic Job Management System 3 Command Reference.