15.3.4 Passing event data containing double quotation marks
Data containing double quotation marks (") can be passed as is to an event job. For details, see 4.3.1(5) Passing event data containing double quotation marks in the JP1/Automatic Job Management System 3 System Design (Configuration) Guide.
The following describes how to set the option that enables the passing of data containing double quotation marks (").
- Organization of this subsection
(1) Definition procedure
-
Stop the JP1/AJS3 service.
Execute the following commands to confirm that all processes have stopped:
# /etc/opt/jp1ajs2/jajs_stop#1 # /opt/jp1ajs2/bin/jajs_spmd_status
- #1:
-
Confirm that automatic termination has been set.
-
Execute the following command to set the environment setting parameter described in (2) below:
jajs_config -k "definition-key" "parameter-name"=value
-
Restart JP1/AJS3.
The new settings are applied.
(2) Environment setting parameter
Definition key |
Environment setting parameter |
Explanation |
---|---|---|
|
"MacVarDQuotation"= |
Specifies whether to enable passing of data containing double quotation marks ("). |
- #:
-
The specification of the {JP1_DEFAULT|logical-host} part depends on whether the host is a physical host or a logical host. For a physical host, specify JP1_DEFAULT. For a logical host, specify the logical host name.
For details about the definition of this environment setting parameter, see 20.6.2(3) MacVarDQuotation.