6.3.1 Agentless Remote Connections area
In the Agentless Remote Connections area, you can view a list of Connection Destinations defined in the system. You can also add, edit, and delete Connection Destination definitions.
You can display the Agentless Remote Connections area by clicking the Agentless Remote Connections menu command in the Administration area.
The items displayed in this area are described below.
- Connection Destinations List
A list of Connection Destinations is displayed. You can sort the list in ascending or descending order by clicking a column header.
Table 6‒2: Items in Connection Destinations List (Agentless Remote Connections area) Item
Description
Method
The method used to specify the Connection Destination (as Host Name, IPv4, or IPv6).
Destination
The host name or IP address of the Connection Destination.
Service Group
The name of the service group to which the Connection Destination belongs.
Protocol
The protocol used when connecting to the Connection Destination.
User ID
The user ID used when connecting to the Connection Destination.
Connection Status
The status when a connection to the agentless remote connection destination was last established. The displayed information varies depending on the connection-destination registration method:-
If the connection destination was registered by using the "single destination" specification method:
A status indicating one of the following is displayed: successfully connected, failed to connect, or not connected.
-
If the connection destination was registered by using the "range of destinations" specification method or the "all destinations" specification method:
A hyphen (-) is displayed.
Connected Time
The time when a connection to the agentless remote connection destination was last established.
-
- Tip
-
-
If you select the check box next to a method of the target agentless remote connection-destination definition and then click the Refresh button, the connection status will be updated with the latest information.
-
If you click the Refresh button (
), the information in the Agentless Remote Connections area will be refreshed.
-