6.6.3 Procedure to perform an overwrite or upgrade installation of JP1/AO on the active server(Linux)
This subsection describes how to overwrite-install or upgrade-install JP1/AO on the active server in Linux.
To perform an overwrite or upgrade installation of JP1/AO on the active server:
Use the cluster software to move the resource group that includes JP1/AO to the active server.
When the upgrade installation target is a cluster environment built with a JP1/AO version earlier than 11-10, if the JP1/Base logical host is running on the active server, stop the logical host.
When the upgrade installation target is a cluster environment built with a JP1/AO version earlier than 11-10, on the active server, start the JP1/Base physical host.
On the active server, overwrite-install or upgrade-install JP1/AO.
On the active server, execute the hcmds64srv command with the status option specified to check the status of each service. If the database for Common Component (HiRDB service) is not running, start the database by executing the hcmds64dbsrv command with the start option specified.
If the HAutomation Engine Web Service is running on the active server, stop the service by executing the hcmds64srv command with the -stop -server AutomationWebService option specified.
On the active server, execute the setupcluster command.
In version 12 or earlier (except in Linux 8), If you edit user_httpsd.conf, you must edit the following items in the file after upgrading.
- SSLProtocol
- SSLCipherSuite