6.5.3 Procedure to perform an overwrite or upgrade installation of JP1/AO on the active server(Windows)
This subsection describes how to overwrite-install or upgrade-install JP1/AO on the active server in Windows.
To perform an overwrite or upgrade installation of JP1/AO on the active server:
Use the cluster software to move the resource group where the JP1/AO service is registered to the active server.
-
(If the upgrade installation target is a cluster environment built with JP1/AO version 10) Unregister the following services from the cluster software:
HiRDB/ClusterService _HD0
HAutomation Engine Web Service
HAutomation Engine logical-host-name
HBase Storage Mgmt Common Service
HBase Storage Mgmt Web Service
stopcluster command
-
When the upgrade installation target is a cluster environment built with a JP1/AO version earlier than 11-10, if the service (JP1/Base_logical-host-name) is online on the active server, bring it offline.
-
When the upgrade installation target is a cluster environment built with a JP1/AO version earlier than 11-10, Start the service (JP1/Base) on the active server.
-
Perform an overwrite or upgrade installation of JP1/AO on the active server.
-
(If the upgrade installation target is a cluster environment built with JP1/AO version 10) On the active server, create a cluster settings file (Common-Component-installation-folder\conf\cluster.conf).
For details, see 5.5 Cluster settings file (cluster.conf).
If the HAutomation Engine Web Service is running on the active server, stop the service by executing the hcmds64srv command with the /stop /server AutomationWebService option specified.
Execute the setupcluster command on the active server.
In version 12 or earlier, If you edit user_httpsd.conf, you must edit the following items in the file after upgrading.
- SSLProtocol
- SSLCipherSuite