6.3.4 Checking the JP1/Base communication protocol
- Organization of this subsection
(1) Checking the JP1/Base communication protocol (on a physical host)
-
Execute the jbsgetcnf command as follows:
jbsgetcnf >config.txt
-
Open config.txt in a text editor.
-
Determine the communication protocol from the contents of the [JP1_DEFAULT\JP1BASE] key.
The following table shows the communication protocol corresponding to each value:
JP1_COM_VERSION
JP1_BIND_ADDR
JP1_CLIENT_BIND_ADDR
Communication protocol
0
Cannot be checked
Cannot be checked
The host is not configured with a communication protocol for multiple LAN connections.
1
ANY
ANY
physical_anyany.conf has been applied.
1
IP
ANY
physical_ipany.conf has been applied.
1
IP
IP
physical_ipip.conf has been applied.
(2) Checking the JP1/Base communication protocol (on a logical host)
-
Execute the jbsgetcnf command with the logical host specified.
jbsgetcnf -h logical-host-name >config.txt
Note that the logical host name must be correctly specified with lower or upper case as specified when the logical host was set up.
-
Open config.txt in a text editor.
-
Determine the communication protocol from the contents of the [logical-host\JP1BASE] key.
The following table shows the communication protocol corresponding to each value:
JP1_COM_VERSION
JP1_BIND_ADDR
JP1_CLIENT_BIND_ADDR
Communication protocol
0
Cannot be checked
Cannot be checked
The host is not configured with a communication protocol for multiple LAN connections.
1
IP
ANY
logical_ipany.conf has been applied.
1
IP
IP
logical_ipip.conf has been applied.
(3) Checking the ANY binding address setting
Check the common definition information by executing the jbsgetcnf command. For details on how to do so, see (1) Checking the JP1/Base communication protocol (on a physical host) and (2) Checking the JP1/Base communication protocol (on a logical host).
The following table shows the ANY binding address setting corresponding to each value:
JP1_ANY_BIND |
ANY binding address setting |
---|---|
IPv4 |
anybind_ipv4.conf has been applied. |
IPv6 |
anybind_ipv6.conf has been applied. |
ALL |
anybind_all.conf has been applied. |
Undefined# |
Only an IPv4 address is bound to the server. |