4.13 Configuring the method for applying system configuration information
System configuration information can be viewed and managed from integrated operation viewer (WebGUI). It also provides the ability to modify setup by downloading and uploading manager and agent defined file from integrated operation viewer, and the ability to generate and reflect IM management node trees.
For detail, refer to 3.6 Operation using WebGUI (integrated operation viewer) in the manual JP1/Integrated Management 3-Manager Overview and System Design Guide.
This section explains the method for applying system configuration information.
You specify the method for applying system configuration information by using options of the jddupdatetree command. Note that if you do not specify the options on the application method with the jddupdatetree command, it follows the definition of the jp1.imdd.simt.updateMode property in the Intelligent Integrated Management Base definition file (imdd.properties).
Specify the new and rebuilding mode in the following cases:
-
When you create a new configuration
-
When you backed up the IM database (jimdbbackup command) and then recovered it (jimdbrecover command)
-
When you unset up the integrated monitoring database (jcodbunsetup command) and set it up again (jcodbsetup command)
-
When you upgraded JP1/IM - Manager in the environment where the Intelligent Integrated Management Base was used
Specify the configuration change mode in the following case:
-
When a managed target of the Intelligent Integrated Management Base is added, removed, or modified in addition to correction of misconfiguration
For details about the jddupdatetree command, see jddupdatetree in Chapter 1. Commands in the manual JP1/Integrated Management 3 - Manager Command, Definition File and API Reference, and for details about the Intelligent Integrated Management Base definition file (imdd.properties), see Intelligent Integrated Management Base definition file (imdd.properties) in Chapter 2. Definition Files in the manual JP1/Integrated Management 3 - Manager Command, Definition File and API Reference.