C.3 Procedure for terminating a system

(1) Flow of terminating a system

The procedure for terminating a system is the reverse of the procedure for starting a system. If you are using a database, LDAP directory server, and EIS, terminate them at the end, as required.

Important note

In some system configurations, you need to stop not only the application server, but also the integrated naming scheduler server.

If you need to stop the application server and the integrated naming scheduler server, note the following:

• You can terminate the integrated naming scheduler servers in any order.

Terminate a system as per the termination operation explained below:

• Terminate the Web server

  For details on terminating a Web server, see the manual on the Web server you are using.

  Note that the timing of terminating the Web server depends on the mode of the system operation, but you can first terminate the Web server for controlling the reception of requests in a J2EE application.

• Terminate J2EE applications

  Terminate a J2EE application using the server management command (cjstopapp). For details on terminating a J2EE application, see C.4 (2) Terminating a J2EE application.

  Note that the next time you start a J2EE application and J2EE server at the same time, you need not terminate the J2EE application.

• Terminate resources

  If you are not using J2EE resources, this operation is not required.

  Terminate the J2EE resource using the server management command (cjstoprar or cjstopjb). For details on terminating resources, see C.4 (3) Terminating a resource.

  Note that the next time you start a J2EE resource while starting a J2EE server, you need not terminate the J2EE resource.

• Terminate J2EE servers

  Terminate the J2EE server using the cjstopsv command. For details on terminating a J2EE server, see C.4 (4) Terminating a J2EE server.

• Terminate a CTM daemon

  If you are not using CTM, this operation is not required.

  Terminate a CTM daemon using the ctmstop command. For details on terminating a CTM daemon, see C.4 (5) Terminating a CTM daemon.

• Terminate the CORBA Naming Service

  The method to terminate the CORBA Naming Service differs depending on how it is invoked. For details on terminating the CORBA Naming Service, see C.4 (6) Terminating the CORBA Naming Service.

• Terminate the CTM domain manager

  If you are not using, this operation is not required.

  Terminate the CTM domain manager using the ctmdmstop command. For details about how to terminate the CTM domain manager, see C.4 (7) Terminating the CTM domain manager.

• Terminate the Smart Agent

  If you have not started the Smart Agent, this operation is not required.

  For details on terminating the Smart Agent, see C.4 (8) Terminating the Smart Agent.

• Terminate the PRF daemon

  Terminate the PRF daemon using the cprfstop command. For details on terminating a PRF daemon, see C.4 (9) Terminating a PRF daemon.

To Page Top