3.3 Commands used with batch applications
This section describes the commands used with batch applications.
The following table lists the commands used with batch applications:
|
Command name |
Function |
Description |
Command group |
|---|---|---|---|
|
Execute batch application |
Executes a batch application. |
-- |
|
|
Stop batch application, or forcibly stop batch server |
Stops a batch application. If an attempt to stop a batch application fails, this command forcibly stops the batch server. |
-- |
|
|
Display a list of the batch application information |
Outputs the information about batch applications with standard output. |
-- |
- Legend:
-
--: Does not apply.
The commands in the above table can use the scheduling functionality of batch applications. For the scheduling functionality of batch applications, see 4. Scheduling of Batch Applications in the uCosminexus Application Server Expansion Guide.
Hereafter, the scheduling functionality of the batch applications is called the scheduling functionality.
For the exclusive control conditions for server management commands of each system, see 3.2 Exclusive access control of server management commands in the uCosminexus Application Server Application Setup Guide.