7.1.3 Notes on using the automated action function
This subsection shows the points you must remember when using the automated action function.
-
Before using the automated action function, start the event server and the remote manager, and the automated action function of JP1/IM - Manager.
-
You cannot use the automated action function when the system starts or when the system terminates.
-
You cannot use the automated action function for the following messages:
-
Response-required messages
-
KDDM0527-E
-
KDDM0528-E
-
-
You cannot use the automated action function if an error occurs while you are using the generator tools to install user data or a user program.
-
If JP1/Base is not active on the system where you want to use the automated action function, client services output the following message; however, client services continue processing:
KDDM0527-E: Could not connect the event server.
-
When you use the automated action function, if the distribution-destination system uses HP-UX, Solaris, or AIX, set the language environment of messages to English, Shift JIS encoding, or EUC encoding. If you set the language environment of messages to UTF-8, you cannot use the automated action function.