4.3.1 Flow of preparing a newly purchased smart device

To use a newly purchased smart device, register it in JP1/ITDM2 - SDM, and then install JP1/ITDM2 - SDM (Smart Device Agent) on the smart device.

The following describes the flow of preparing a new smart device.

1. Check the root certificates for SSL communication preinstalled on the smart device.

2. Set the root certificates for SSL communication on the smart device (only when necessary certificates are not preinstalled).

3. Register the smart device in JP1/ITDM2 - SDM.

   Set the security policy and Android policy (or the security policy and iOS profile) appropriate for the user, and then register the smart device as Managed.

4. Install JP1/ITDM2 - SDM (Smart Device Agent) on the smart device.

Related Topics

• 3.14.3 Procedure for checking the root certificates for SSL communication preinstalled on the smart device

• 3.14.4 Procedure for setting up the root certificate for SSL communication on the Android device

• 3.14.5 Procedure for setting root certificates for SSL communication on the iOS device

• 3.14.6 Procedure for installing JP1/ITDM2 - SDM (Smart Device Android Agent) on an Android device (using the Android device only)

• 3.14.7 Procedure for installing JP1/ITDM2 - SDM (Smart Device Android Agent) on an Android device (for a PC)

• 3.14.8 Procedure for installing JP1/ITDM2 - SDM (Smart Device iOS Agent) on an iOS device

• 8.1 Registering smart devices in JP1/ITDM2 - SDM

To Page Top