3.14.6 Procedure for installing JP1/ITDM2 - SDM (Smart Device Android Agent) on an Android device (using the Android device only)
Install JP1/ITDM2 - SDM (Smart Device Android Agent) (application name: JP1ITDM2SDM) on the Android device, and then set up JP1/ITDM2 - SDM (Smart Device Android Agent). This procedure uses the Android device only.
Procedure
-
Deploy the installation file of Smart Device Android Agent to a Web server accessible from Android devices.
JP1/ITDM2 - SDM (Smart Device Manager)-installation-folder\mgr\agent\JP1ITDM2-SDMAgent.apk
-
Access the download site on the above Web site from Android devices and then download the Android Agent.
-
Tap the Android Agent you downloaded from the notification message and then install the Android Agent.
Note that you need to allow Settings - Security - Unknown sources. Therefore, change the setting to Allow installation of apps from sources other than the Play store.
#: The menu name might be different for each device.
JP1/ITDM2 - SDM (Smart Device Android Agent) is installed.
-
Confirm that the [Activate device administrator?] dialog is displayed after installing the Android Agent, and then tap Activate.
In Settings - General - Security - Device administration - Deviceadministrators, confirm that the check box of the Android Agent (application name: JP1ITDM2SDM) is enabled. If the check box is disabled, tap the Android Agent (application name: JP1ITDM2SDM) and then tap Activate in the displayed Activate device administrator? dialog to enable the Android Agent.
-
On the Android device, start JP1/ITDM2 - SDM (Smart Device Android Agent).
-
In the Settings window, enter the host name of the connection destination communication server and smart device name, and then tap OK.
For the communication server, enter the host name in host-name:26055 format. For the name, specify the smart device name registered in JP1/ITDM2 - SDM.
When the server is connected successfully, a dialog box indicating so appears.
-
Tap OK in the dialog box.
Related Topics