19101 <Information>
Flow control for the distribution function that uses Remote Install Manager is disabled.
- Cause
-
Possible causes are as follows:
-
Failed to open the configuration file (jdn_rim_distr_bwc.conf).
-
The BandwidthCtrl section was not found in the configuration file.
-
The Function key was not found in the BandwidthCtrl section.
-
The Function key was not enabled for the BandwidthCtrl section.
-
There is no valid SettingN section.
-
- Action
-
-
Make sure that the configuration file exists.
-
Make sure that the BandwidthCtrl section exists in the configuration file, and that the Function key is enabled.
-
Make sure that a valid SettingN section is present.
-