Hitachi

JP1 Version 12 JP1/IT Desktop Management 2 - Asset Console Configuration and Administration Guide


16.8.1 Adding codes

To add a code:

  1. In the Managed class list, click the link of the class to which a code is to be added.

    The code ID of the selected class is displayed.

    Some code information cannot be added. For details about the code information that cannot be added, see 16.8.6 Code information that cannot be added or deleted.

  2. Click the link of the Code ID to which a code is to be added.

    The code and the corresponding display value are displayed.

    The contract information and company catalog, and the hardware information and device catalog share code information. For details about the shared codes, see 16.8.5 Code IDs shared among multiple classes.

  3. Click the Add button.

    The Add Code dialog box is displayed.

    Code value and Display value must be specified. You cannot add a code or display value that has already been registered.

    Note that the meaning of a code might depend on the numerical range in which it is specified. The code ranges that can be specified have specific code IDs. For details about the code specification ranges, see 16.8.4 Meaning of codes depending on specification range.

    To cancel, click the Close button.

  4. Click the OK button.

    The code is added based on the specified information, and the Add Code dialog box closes.

The following figure shows the Add Code dialog box in which a code to be registered is specified.

Figure 16‒25: Add Code dialog box

[Figure]

Note

To add a code to CPUType and OSType for items added by JP1/IT Desktop Management 2 - Manager, make sure that the added code matches JP1/IT Desktop Management 2 - Manager's system information CPU type.

Note that CPUType is used with an automatically-added value in the range from 90000 to 90999. If you add a unique code to CPUtype, make sure that the specified value is in the range from 00000 to 89999, or from 91000 to 99999.