AIT_VerifyCharPos
- Organization of this page
Description
Checks a character position in a specific control on the active window.
Format
integer AIT_VerifyCharPos ( string strCaption, // Control's caption integer nCtrlType, // Control type integer nVerifyPos // Character position ); integer AIT_VerifyCharPos ( integer nCtrlID, // Control ID integer nCtrlType, // Control type integer nVerifyPos // Character position );
Parameters
strCaption (input)
Specify the caption of a control.
nCtrlID (input)
Specify a control ID.
nCtrlType (input)
Specify a control type for which only EDIT_CTRL is valid.
nVerifyPos (input)
Specify the positional value of a character to be checked. Because 0-based positioning is used, the position of the first character in the edit box is 0.
Return values
The return value is 1 if the found position is the same as a specified one, 0 if not, and -1 if the function has not been processed normally. If -1 has been returned, you can use AIT_GetLastError to acquire an extended error code. The following gives the error codes that AIT_GetLastError might return:
Extended error number |
Error code |
---|---|
8 |
ERROR_NOT_ENOUGH_MEMORY |
14 |
ERROR_OUTOFMEMORY |
87 |
ERROR_INVALID_PARAMETER |
112 |
ERROR_DISK_FULL |
1400 |
ERROR_INVALID_WINDOW_HANDLE |
1460 |
ERROR_TIMEOUT |
Note
You can identify the control by using a complete caption or an associated label name or specifying the first part of such a caption or label name. When specifying the first part, prefix a swung dash (~) to the character string that you specify.