14.18 catAndValidatePackagingFile.exe (combining split files)
This section describes the catAndValidatePackagingFile command, which combines files that are split.
Function
This command combines files split by the dcmpack command into one file. If a folder is split, it checks if all the files in the folder exist.
Format
catAndValidatePackagingFile.exe /d name-of-the-folder-where-split-files-are-stored
Arguments
-
/d
Specify the full path, within 255 characters, to the folder where split files are stored.
If the folder name contains a single-byte space character, enclose the path in double quotation marks ("). The combined file is stored in the folder where the split files are stored. When the command ends, the split files are deleted automatically.
Return codes
The following table lists the return codes that are output when the catAndValidatePackagingFile command is executed:
Code |
Meaning |
Action to be taken |
---|---|---|
0 |
The command ended normally. |
None |
11 |
An error was found in an argument. |
Check the value set in the argument. |
21 |
No split files exist, or no read access permissions are assigned. |
Check that the file for the package created by the dcmpack command exists in the folder where split files are stored. If the file does not exist, re-execute the remote installation job for the applicable package. |
32 |
An error occurred when the combined file was output. |
Check the existence of the folder where split files are stored, the access permissions, and the free space of the folder. |
33 |
An error occurred when the combined file was verified. |
Re-execute the remote installation job. |
150 |
The command execution was interrupted due to another error. |
Collect maintenance data, and then contact the system administrator. |