8.6.4 Assigning network monitor settings
You can assign network monitor settings to each network segment, and manage network connections of newly discovered devices in each network segment.
- Tip
-
To assign network monitor settings, the network monitor function must be installed on the network segment.
- Important
-
You cannot enable network monitors on agents for UNIX or Mac.
- Important
-
In a multi-server configuration, you can assign network monitor settings only to the computers immediately under the local server.
To assign network monitor settings:
-
Display the Settings module.
-
In the menu area, select Network Access Control and then Assign Network Access Control Settings.
-
In the upper part of the information area, select the network segment where the network monitor settings are to be assigned. Next, in the lower part of the information area, select the computer for which the network monitor is to be enabled. Finally, click Enable Network Access Control.
-
In the displayed dialog box, select the network monitor settings to be assigned, and then click OK.
The network monitor settings are assigned to the network segment, and displayed in the list of assigned network monitor settings.