7.5.8 Setting automatic disconnection for a remotely controlled computer
You can monitor computers that are not being operated on or whose Remote Controller window is inactive, and automatically disconnect such a computer after the status continues for a set amount of time.
To set automatic disconnections for a computer:
-
On the toolbar of the Remote Controller window, click the Options button.
-
On the Connection tab of the displayed dialog box, select Auto Disconnect when idle, and then specify the wait time from the operating stops until the computer is disconnected.
Based on the above settings, the computer is automatically disconnected from when the specified time elapses since an operation was last performed on the computer (no data is transferred).
- Tip
-
After the disconnection, if you select File and then Reconnect from the menu of a Remote Controller window, the computer that was disconnected from by using the Remote Controller window is reconnected.
However, depending on the settings on the computer, the remote control agent might automatically stop at the time of the disconnection. In this case, restart the remote control agent, and then reconnect to the computer.