Hitachi

JP1 Version 12 JP1/Extensible SNMP Agent Description, Operator's Guide and Reference


2.3.2 Setting the SNMP trap transmission port number (when performing overwrite installation on version 07-10 or earlier)

If you are performing overwrite installation on SNMP Agent version 07-10 or earlier, and if you have specified a value other than 161/udp for the SNMP reception port, you must specify 162 for the SNMP trap transmission port number (SR_TRAP_TEST_PORT environment variable) after you have installed SNMP Agent.

Use the following procedure to set the SNMP trap transmission port number.

Procedure

  1. Add the following two lines in the SnmpMaster file, which is used by the snmpdm process:

    SR_TRAP_TEST_PORT=162
    export SR_TRAP_TEST_PORT
  2. Use the snmpstart command to start SNMP Agent.