3.3.2 Unsetup procedure in Windows

(1) Canceling setup of an instance environment

To cancel setup of an instance environment, first verify the instance name and then delete the instance environment. You cancel an instance environment at the PFM - Agent host.

Use the jpcconf inst list command to verify the instance name, then use the jpcconf inst unsetup command to delete the existing instance environment.

To cancel setup of an instance environment:

1. Find the instance name.

   Execute the jpcconf inst list command with the service key of PFM - Agent for Enterprise Applications specified.

   jpcconf inst list -key EAP 

   If the current instance name is o246bciSD500, the command displays o246bciSD500.

2. If a PFM - Agent service is running in the instance environment, stop the service.

   For details about stopping services, see the chapter that describes starting and stopping services in the JP1/Performance Management User's Guide.

3. Delete the instance environment.

   Execute the jpcconf inst unsetup command with the service key and instance name of PFM - Agent for Enterprise Applications specified.

   For example, if the existing instance name is o246bciSD500, enter the following command:

   jpcconf inst unsetup -key EAP -inst o246bciSD500

   If the jpcconf inst unsetup command is successful, the folders, service ID, and Windows services created as the instance environment are deleted.

Note

Canceling an instance environment might not delete the service information that is displayed by the jpctool service list command. For details about how to delete the service information, see the section on deleting services in the chapter that describes installation and setup in the JP1/Performance Management Planning and Configuration Guide.

To Page Top