Alloc Mem Mbytes
- Organization of this page
Overview
The Alloc Mem Mbytes alarm monitors the amount of used virtual memory area (MB). If the amount of used memory continues to be at or above the threshold (the Total Physical Mem Mbytes field value of the PI record), physical memory might be insufficient.
Primary settings
PFM - Web Console alarm property |
Settings |
|
---|---|---|
Item |
Detailed item |
|
Main Information |
Product |
UNIX |
Alarm message |
Alloc Mem Mbytes = %CVS1 |
|
Enable alarm |
Selected |
|
Alarm notification |
Notify when the state changed |
|
Notification target |
State changes for the alarm |
|
Evaluate all data |
Do not specify. |
|
Monitoring time range |
Always monitor |
|
Report alarm when the following damping condition is reached |
Selected |
|
occurrence(s) during |
2 |
|
interval(s) |
3 |
|
Alarm Conditions |
Record |
System Summary Overview (PI) |
Field |
Alloc Swap Mbytes |
|
Abnormal condition |
Alloc Swap Mbytes >= 1800#1 |
|
Warning condition |
Alloc Swap Mbytes >= 1024#2 |
|
Actions |
|
-- |
Command |
-- |
|
SNMP |
Abnormal, Warning, Normal |
- Legend:
-
--: Setting is always ignored.
- #1
-
Depending on the environment, set a value that is about 90% of the value of the Total Swap Mbytes field of the PI record (except when the Solaris zone functionality is being used).
- #2
-
Depending on the environment, set the value of the Total Physical Mem Mbytes field of the PI record (except when the Solaris zone functionality is being used).
Alarm tables
PFM UNIX Template Alarms [MEM] 09.00
Related reports
None