1.7.5 Properties window
The Service Properties window displays the properties (definition) of a selected alarm. To display this window, in the Alarms window, from the method frame, choose Properties.
The following figure shows the Properties window.
|
|
![[Figure]](GRAPHICS/ZU201720.GIF)
If you click the link displayed at the top of the window, you can jump to the area where the applicable information is displayed. For details about the display items in each area, see 1.7.4 Windows for creating new alarm definitions and editing existing alarm definitions.
The following describes the displayed items:
- Close
-
Closes the Properties window.
- Main Information
-
Displays the General settings and Advanced settings that were set in the New Alarm > Main Information window or the Edit > Main Information window.
- Alarm Conditions
-
Displays the Alarm Conditions settings that were set in the New Alarm > Alarm Conditions window or the Edit > Alarm Conditions window.
- Actions
-
Displays the Actions to be executed and Report to be displayed settings that were set in the New Alarm > Action window or the Edit > Action window.
- Action Definitions
-
Displays the Email Settings and Command Definition settings that were set in the New Alarm > Action Definitions window or the Edit > Action Definitions window.