12.3 Installation and setup when linking with JP1/IM

This section describes the installation and setup procedures for setting up an environment for linking with JP1/IM.

When linking with JP1/IM, make sure that PFM - Manager uses the same character set as the instance of JP1/IM with which you are linking. If the character sets are different, double-byte characters and single-byte Katakana characters will not be displayed correctly.

Organization of this section

• 12.3.1 Prerequisites for installation when linking with JP1/IM

• 12.3.2 Setup for linking with JP1/IM (settings for using JP1/IM to monitor events that occurred in Performance Management)

• 12.3.3 Setup for linking with JP1/IM (settings for displaying reports from events in the Central Console)

• 12.3.4 Releasing linkage with JP1/IM

To Page Top