10.6 Deleting a logical host from a cluster environment
To remove a logical host for JP1/Service Support from a cluster environment:
-
Switch the active node from the primary node to secondary node.
Use the cluster software to switch the nodes.
-
On the secondary node, use the cluster software to delete registered services.
-
On the secondary node, perform unsetup of the logical host.
From the Start menu, select Programs, JP1_Service Support, and then JP1_SS Command Prompt. Execute the jsshaunsetup.bat command. For details about the jsshaunsetup.bat command, see jsshaunsetup.bat (performs unsetup of JP1/Service Support in a cluster environment) in Chapter 12. Commands.
-
Switch the active node from the secondary node to primary node.
Use the cluster software to switch the nodes.
-
On the primary node, perform unsetup of the logical host.
From the Start menu, select Programs, JP1_Service Support, and then JP1_SS Command Prompt. Execute the jsshaunsetup.bat command. For details about the jsshaunsetup.bat command, see jsshaunsetup.bat (performs unsetup of JP1/Service Support in a cluster environment) in Chapter 12. Commands.
-
Use the cluster software to delete registered resources.
This step is not necessary when you reuse resources.