10.2.9 Setting an authentication server

If you use an LDAP server or a JP1/Base authentication server as the authentication server, execute the jsschauthorityserver command following the procedure below. This procedure is not necessary if you do not use an LDAP server or a JP1/Base authentication server.

1. Execute the jsschauthorityserver command on the primary node.

   For details about the jsschauthorityserver command, see jsschauthorityserver (switches the authentication method) in Chapter 12. Commands.

2. Switch the active node from the primary node to the secondary node.

3. Execute the jsschauthorityserver command on the secondary node.

   For details about the jsschauthorityserver command, see jsschauthorityserver (switches the authentication method) in Chapter 12. Commands.

4. Switch the active node from the secondary node to the primary node.

To Page Top