3.21 Cluster system support

JP1/Service Support supports operation in a cluster system. If a failure occurs on the active server while JP1/Service Support is operating in a cluster system, the standby server can continue operation without an interrupt.

The following figure shows a typical configuration for using JP1/Service Support in a cluster system.

Figure 3‒51: Example of using JP1/Service Support in a cluster system

For details about operation in a cluster system and how to set up a cluster environment, see Chapter 10. Using JP1/Service Support in a Cluster System and Configuring an Environment. This section describes only how JP1/Service Support behaves when a failover occurs and the commands that can be executed on the active and standby servers.

Organization of this section

• 3.21.1 How JP1/Service Support behaves when a failover occurs

• 3.21.2 Commands that can be executed on the active and standby servers

To Page Top