KAVB2003-E
Cannot connect to host-name host; so, the command-name command cannot be executed.
The command cannot be executed because the command destination host cannot be connected.
- (S)
-
Does not execute the command.
- (O)
-
To correct the cause of the error, check the environment to make sure that:
-
The network is in the normal status.
-
Both the local host and the command destination host use the same IP address version (IPv4 or IPv6).
-
JP1/Base is running on the command destination host.
-
If the communication encryption function is in use, the settings for the communication encryption function are correct.
If the problem cannot be corrected, use the data collection tool to collect data for the local host and the command destination host, and then contact the system administrator.
For details about how to check the IP address version (IPv4 or IPv6), see the description of the jp1ping command in the chapter on commands in the JP1/Base User's Guide.
-