8.1 User management setup (in Windows)

If you use automatic setup to install JP1/Base, JP1/Base is installed with the default settings. For details on the default settings that apply when you set up JP1/Base automatically, see 3.2.1 Installing JP1/Base.

The setup method differs depending on whether the host will be used as an authentication server.

If you use the secondary authentication server, the setting information for both the primary authentication server and the secondary authentication server must be the same. The following figure shows the setup procedure required on each host and the corresponding sections in this manual.

Figure 8‒1: User management setup procedure (in Windows)

In Windows, you can use the GUI or commands to set up user management. To display the GUI, from the Windows Start menu, choose Programs, JP1_Base, and then JP1_Base Setup. The JP1/Base Environment Settings dialog box appears. Note that administrative permissions are required to operate the GUI. The following figure shows the JP1/Base Environment Settings dialog box.

Figure 8‒2: JP1/Base Environment Settings dialog box

Organization of this section

• 8.1.1 Specifying the authentication servers to use

• 8.1.2 Setting JP1 users (standard users)

• 8.1.3 Setting JP1 user operating permissions

• 8.1.4 Copying settings from the primary authentication server

• 8.1.5 Assigning user permissions to OS users before setting user mapping

• 8.1.6 Using the GUI to set user mapping

• 8.1.7 Using commands to set user mapping

• 8.1.8 Notes on user management setup

To Page Top