3.2.1 Installing JP1/Base
To install JP1/Base:
-
Quit all programs.
Be sure to quit all JP1 programs, and all programs that are currently accessing the JP1/Base event service, before you install JP1/Base.
-
Insert the supplied media into the drive.
Install JP1/Base as prompted by the Installer.
During installation, set the following items:
-
User information
-
Installation folder
The default installation folder is as follows:
In an x86 environment:
system-drive\Program Files\Hitachi\JP1Base
In an x64 environment:
system-drive\Program Files (x86)\Hitachi\JP1Base
Note: Do not install the files under system-drive\Program Files in an x64 environment. Doing so might cause problems as a result of mixing with 64-bit modules.
-
The Automatic Setup Selection window appears only when you perform a new installation of JP1/Base. If you select Perform setup processing, the installer automatically initializes JP1/Base so that it is ready for operation immediately after installation completes.
The following items are set when you select automatic setup.
If you choose not to perform automatic setup, only the JP1 user settings need to be entered.
For details on each item, see 8.1 User management setup (in Windows).
At execution, the Installer automatically installs the Hitachi Network Objectplaza Trace Library (HNTRLib2). The installation folder is as follows:
In an x86 environment:
system-drive\Program Files\Hitachi\HNTRLib2
In an x64 environment:
HNTRLib2 for 32bit
system-drive\Program Files (x86)\Hitachi\HNTRLib2
HNTRLib2 for 64bit
system-drive\Program Files\Hitachi\HNTRLib2
This installation folder is fixed in the system drive. You cannot change the location.
-
-
Restart the system.
Restart Windows if prompted.
- Remote installation of JP1/Base (software deployment) through JP1/NETM/DM, JP1/IT Desktop Management 2 and Job Management Partner 1/Software Distribution
-
JP1/Base supports remote installation through JP1/NETM/DM, JP1/IT Desktop Management 2 and Job Management Partner 1/Software Distribution. JP1/Base allows you to perform the following types of installation:
-
Installation of a new program
You can install a new JP1/Base program in the target host. Remote installation using JP1/NETM/DM, JP1/IT Desktop Management 2 and Job Management Partner 1/Software Distribution does not support automatic setup.
-
Upgrade to a newer version
You can upgrade an existing JP1/Base program to a newer version on the target host through remote installation.
See JP1/NETM/DM, JP1/IT Desktop Management 2 or Job Management Partner 1/Software Distribution Manual for more information.
Be sure to use a JP1/NETM/DM 09-00 or later packager, a JP1/IT Desktop Management 2 packager or a Job Management Partner 1/Software Distribution 09-00 or later packager to package this software product.
JP1/NETM/DM is sold only in Japan.
-