3.1 Environment setup procedure

Use of JP1/IM - EG for NNMi in a cluster system is supported. When you use JP1/IM - EG for NNMi in a cluster system, processing can be inherited from the primary node to the secondary node in the event of a server failure.

If you intend to run JP1/IM - EG for NNMi in a cluster system, make sure in advance that operation of JP1/IM - EG for NNMi is supported by your cluster software.

This section describes the environment setup procedure for running JP1/IM - EG for NNMi in a cluster system.

You must have Administrator permissions in Windows and superuser permissions in UNIX in order to perform the installation and setup procedures.

Figure 3‒1: Environment setup procedure (cluster operation)

Installing JP1/Base

For details about how to install and set up JP1/Base and how to specify cluster settings, see the JP1/Base User's Guide.

Installing NNMi

You can install NNMi at any time. However, if you intend to run JP1/IM - EG for NNMi in a cluster system, you must first install and set up NNMi. For details about how to set up NNMi, see the manuals and Release Notes for NNMi.

At the time you set up JP1/IM - EG for NNMi, you will need the NNMi settings. For details about the NNMi settings that will be required during setup, see Table 2-1 NNMi settings required during setup in 2.1 Installation and setup procedures.

To Page Top